DECALS

14 - Decals (£0)

These were all made on the computer, using pictures from lots of sites. The chest display section was printed on acetate film (transparent and reflective), then stuck onto bright red paper. Holes were cut in the left chest panel (templates somewhere!), and the acetate section put behind this to create a little depth. The jetpack sections and the other decals were cut out and stuck on where needed.

The Blue Peter badge was stuck on the back of the jetpack as a joke, but it was too small and nobody noticed it. Everything other than the helmet was completely home-made (and even that had been considerably altered and improved).

These are the decals used on the body armour. They are in proportion to each other, but not the correct size. The big skull one should be 9.5cm tall by about 5cm wide.
They were printed on paper, covered in sticky-back plastic and mounted on double-sided tape. The were then cut out and stuck on where needed.
These are the decals used on the jetpack (again, are not the correct size). The 2 L-shaped ones were for the front of the jetpack, on either side of the yellow central bottle. They covered the cardboard between there and the hexagonal tubes.
I used one of the vertical strips to put under the clear plastic strip used to secure the thing together.

NEXT... THE END BIT

 

INTRO
INTRO
HELMET
HELMET
JUMPSUIT
JUMPSUIT
ARMOUR
ARMOUR
CODPIECE
CODPIECE
GIRTHBELT
GIRTH BELT
BOXBELT
BOX BELT
GUARDS
SHOULDER & KNEE GUARDS
GAUNTLETS
GAUNTLETS
GUN
GUN
SCALPS
WOOKIE SCALPS
CAPE
CAPE
BOOTS
BOOTS
JETPACK
JETPACK
DECALS
DECALS
OUTRO
OUTRO